Before you begin Read the legal guidelines on this website. Place your Creative Zen Vision W on a clean flat and soft surface, such as a rubber mat or a piece of soft cloth and get the required opening tools
		Step 1
		Step 2 Remove the 2 screws next to the dock connector.
		Step 3 Remove the 2 screws next to the power button and the volume buttons.
		Step 4 Insert the opening tool between the screen and bezel. Avoid pushing on the screen, just pull the tool upward as you slide it along the edges of the the bezel.
		Step 5 Slide the tool to the opposite edge of the bezel and pull the bezel upward to release it from the creative vision W body.
		Step 6 Repeat the last steps and pull the safe open tool toward you. When the bezel comes loose you can lift it up as shown in the image.
		Step 7 Keep the creative zen button pad aside and be sure not to lose the small blind.
		Step 8 Use the small flathead to pry between the four clips holding the screen in place.
		Step 9 When the frame clips are released the screen can be flipped forward. Do not pull the screen ribbon cables.
		Step 10 On the right side you see the screen connector, the smaller ribbon cable on the left is for the backlight.
		Step 11 Carefully open the screen connector latch.
		Step 12 Push the right side of backlight connector latch in direction of the ribbon cable.
		Step 13 Push the left side of backlight connector latch in direction of the ribbon cable.
		Step 14 The ribbon cables will now come loose from the board. Install the new creative Zen Vision W screen and follow the steps in reverse order to complete the repair.

		Before you begin Read this website's Legal Guidelines and make sure you understand the risks of this repair. Place your Creative Zen Sleek on a clean flat and soft surface, such as a rubber mat or a piece of soft cloth and get the required opening tools
		Step 1
		Step 2
		Step 3
		Step 4
		Step 5
		Step 6
		Step 7
		Step 8
		Step 9
		Step 10
		Step 11
		Step 13
		Step 12
		Step 15
		Step 16
		Step 17
		Step 18
		Step 19